A flexible overdrive platform combining four clipping voices, four boost presets, Gain Cycle, studio-grade active EQ, and MIDI control.
A familiar soft-clipping foundation without a permanently imposed mid hump. With the EQ controls centered, the response remains relatively flat and ready to shape.
The Prism-inspired MOSFET boost lives in its own true-bypass loop, allowing it to push the drive circuit, another pedal, or your amplifier independently.
Hold the Boost footswitch to enter program mode, then tap it to move through the four EQ presets.
A thinner, brighter response that can add definition to thick overdrive sounds.
Retains more lows than Bright mode while adding a focused midrange push.
A balanced voice designed to complement a wide variety of overdrive settings.
Transparent output with no intentional tonal coloring—your guitar, only louder.
Each clipping preset is level matched, helping you hear the actual difference in response and character instead of a distracting volume jump.
Two symmetrical silicon diodes provide familiar compression and classic soft-clipping drive.
Three asymmetric silicon diodes create a more complex response suited to aggressive rhythm tones.
Four symmetrical silicon diodes produce a focused and direct clipping response.
Symmetrical red LED clipping delivers greater headroom with a more open and less compressed feel.
Set the Gain knob as your maximum. Press both footswitches simultaneously to cycle through four percentages of that setting.
Edge of breakup
Defined overdrive
Heavy overdrive
Maximum saturation
A guitar-focused Baxandall-style active EQ provides wide control while remaining flat at noon.
Volume: Master output for the overdrive circuit.
Boost: Sets the output of the independent boost.
Gain: Sets the maximum value used by Gain Cycle.
Bass: Active low-frequency boost or cut.
Middle: Active boost or cut centered around 660Hz.
Treble: Active high-frequency boost or cut.
An internal jumper lets you choose between the standard quiet boost and an alternate traditional MOSFET configuration.
STND: Full boost character without control noise.
ALT: Slightly more maximum gain with the traditional crackle when rotating the Boost control.
Broken Arrow V2 receives MIDI through the ring connection of a TRS connector. A MIDI DIN-5 to TRS conversion cable is required.
The pedal ships on MIDI Channel 1. To change channels, hold the Drive footswitch while applying power, then tap Boost to increment the channel. The Boost LED flashes the selected channel number. Release Drive to save and reboot.
CC #1Drive on/off0 / 127
CC #2Boost on/off0 / 127
CC #3Clipping preset1–4
CC #4Gain Cycle1–4
CC #5Boost EQ1–4
Input impedance1MΩ
Output impedance100kΩ
Power9V DC maximum
PolarityCenter negative
Minimum current150mA
Dimensions2.7″ × 4.875″
